-
Material :
Chrome steel , triple plated Copper / Nickel / Chrome, With Phenolic Plastic Emblem.
-
Neck Size : 5 1/8" most four barrels, two barrel adapters are available in the air cleaner accessories category
-
Emblems : approximately 1/8" thick and are red and chrome ,heat and fuel resistant .The are adhered with a thermal adhesive then baked @ 260 degrees to set the emblem in place and cannot be removed without damaging them
-
Stud and wing nut : A new stud and standard wing nut will be taped to the inside of your air cleaner when you receive it. If you would like a fancy wing nut for your air cleaner checkout MCC1048 , MCC1039 or MCC1059
-
Recessed Base
: This air cleaner comes with a recessed base . It has a total height of 3" from the carb flange( not including wing nut). It will fit most Holley carburetors and was designed for Holley double pumper carbs . If you are running an Edelbrock carburetor you will need to use MCC150c 1/2 riser to cleaner the fuel line and/or choke housing.
-
Air Filter : Common 14 x 3 paper element, so when you need to replace the air filter you can find it locally or we also carry replacement filters when needed MCC303-3E, if you would like to add a K&N filter to your order it is MCC1650
-
Application : Generally all Big Block Chevy's from 1965 -1990 (carburetor only).
-
Installation tips : Be sure to install the stud into your carburetor and check your hood clearance to the stud before closing the hood to avoid damaging your hood .If necessary cut the stud to the correct height and reinstall
-
Valve Covers : This set is TALL height (approximately 3 1/2" tall) They will NOT clear factory air conditioning brackets. Each valve cover has one hole in it for accessories. They CAN be run with most aftermarket roller rockers
-
Baffled : YES, these valve covers come with steel baffles in each
-
Gaskets : NO, these do not come with gaskets, Any Quality gasket made for the big block Chevy will work on these valve covers
-
Valve Cover Accessories : Hold downs, breathers, PCV valves etc. DO NOT come with the valve covers but can be located on the left side links on this page and purchased separately . Each valve cover has 7 mounting holes so you will need 14, bolts or spreaders etc. when ordering for this set
-
Installation tips : When tightening your valve cover start on the low side and tighten in a cross pattern to the correct torque spec . Do not over tighten the valve covers when installing them!
-
Comments :
-
If you would like this valve cover and air cleaner combo in factory height valve covers use MCC16667s
-
If you would like a plain chrome valve cover and air cleaner combo without emblems in TALL valve covers use MCC303108T and for stock height use MCC303108s
-
All MotorChrome part numbers can be pulled up by typing the MCC# into the search box
