-
Material :
Chrome steel , triple plated Copper / Nickel / Chrome, With Phenolic Plastic Emblem.
-
Neck Size : 5 1/8" most four barrels, two barrel adapters are available in the air cleaner accessories category
-
Emblems : approximately 1/8" thick and are red and chrome ,heat and fuel resistant .The are adhered with a thermal adhesive then baked @ 260 degrees to set the emblem in place and cannot be removed without damaging them
-
Stud and wing nut :
A new stud and standard wing nut will be taped to the inside of your air cleaner when you receive it. If you would like a fancy wing nut for your air cleaner checkout MCC1048 , MCC1039 or MCC1059
-
Recessed Base
:
This air cleaner comes with a recessed base . It has a total height of 3" from the carb flange( not including wing nut). It will fit most Holley carburetors and was designed for Holley double pumper carbs . If you are running an Edelbrock carburetor you will need to use MCC150c 1/2 riser to cleaner the fuel line and/or choke housing.
-
Application : Mopar Or Small Block Chevy stroker engines
-
Installation tips : Be sure to install the stud into your carburetor and check your hood clearance to the stud before closing the hood to avoid damaging your hood .If necessary cut the stud to the correct height and reinstall
-
Comments :
-
If you would like the matching valve covers for 383 Mopar use part number MCC59 for Small Block Chevy Use MCC160T
-
If you would like both the matching valve cover and air cleaner combo use MCC167359 383 Mopar or MCC167160T for Small Block Chevy.
-
All MotorChrome part numbers can be pulled up by typing the MCC# into the search box
