-
Material :
Chrome steel , triple plated Copper /
Nickel / Chrome,
-
Neck Size : 5 1/8" fits most four barrels, two barrel
adapters are available in the air cleaner accessories
category
-
Stud
and wing nut :
A new stud and
standard wing nut will be taped to the inside of your air
cleaner when you receive it. If you would like a fancy
wing nut for your air cleaner checkout MCC1048 ,
MCC1039 or MCC1059
-
Recessed Base
: This air cleaner comes with a recessed base . It has a
total height of 3" from the carb flange( not including
wing nut). It will fit most Holley carburetors and was
designed for Holley double pumper carbs . If you are
running an Edelbrock carburetor you will need to use
MCC150c 1/2 inch riser to cleaner the fuel line and/or choke
housing.
-
Air Filter : Common 14 x 3 paper element, so when
you need to replace the air filter you can find it locally
or we also carry replacement filters when needed
MCC303-3E, if you would like to add a K&N filter to your
order it is MCC1650
-
Application :
Big Block Chevy 396 - 427 - 454 - 502 engines
-
Installation tips :
Be sure to install the stud
into your carburetor and check your hood clearance to the
stud before closing the hood to avoid damaging your hood
.If necessary cut the stud to the correct height and
reinstall
-
Valve Covers : This set is
Tall
(approximately 3 1/2" tall) They will NOT clear
factory air conditioning brackets. Each valve cover has
one hole in it for accessories. They CAN
be run with most aftermarket roller rockers
-
Baffled :
YES, these valve covers come with steel
baffles in each
-
Gaskets :
NO, these do not come with gaskets, Any
Quality gasket made for your engine will work on
these valve covers
-
Valve Cover Accessories :
Hold downs, breathers,
PCV valves etc. DO NOT come with the valve covers but can
be located on the left side links on this page and
purchased separately . Each valve cover has 7 mounting
holes so you will need 14, bolts or spreaders etc. when
ordering for this set
-
Installation tips :
When tightening your valve cover
start on the low side and tighten in a cross pattern to
the correct torque spec . Do not over tighten the valve
covers when installing them!
-
Comments :
-
If you would like Just the
valve covers use MCC108T
-
If you would like Just the air cleaner use MCC303-3
-
If you would like a chrome
valve cover and air cleaner combo with HP emblems use ether
MCC16667T (for 396) MCC66365T (for 427) MCC10595T(
for 454)
-
All MotorChrome part numbers
can be pulled up by typing the MCC# into the search box
