-
Material :
Chrome steel , triple plated Copper / Nickel / Chrome,
-
Neck Size : 5 1/8" fits most four barrels, two barrel adapters are available in the air cleaner accessories category
-
Stud and wing nut : A new stud and standard wing nut will be taped to the inside of your air cleaner when you receive it. If you would like a fancy wing nut for your air cleaner checkout MCC1048 , MCC1039 or MCC1059
-
Recessed Base
: This air cleaner comes with a recessed base . It has a total height of 3" from the carb flange( not including wing nut). It will fit most Holley carburetors and was designed for Holley double pumper carbs . If you are running an Edelbrock carburetor you will need to use MCC150c 1/2 inch riser to cleaner the fuel line and/or choke housing.
-
Air Filter : Common 14 x 3 paper element, so when you need to replace the air filter you can find it locally or we also carry replacement filters when needed MCC303-3E, if you would like to add a K&N filter to your order it is MCC1650
-
Application : Big Block Mopar 361 - 383 - 440
-
Installation tips : Be sure to install the stud into your carburetor and check your hood clearance to the stud before closing the hood to avoid damaging your hood .If necessary cut the stud to the correct height and reinstall
-
Valve Covers : This set is factory height. They will clear factory air conditioning brackets. Each valve cover has one hole in it for accessories.
-
Baffled : YES, these valve covers come with steel baffles in each
-
Gaskets : NO, these do not come with gaskets, Any Quality gasket made for your engine will work on these valve covers
-
Valve Cover Accessories : Hold downs, breathers, PCV valves etc. DO NOT come with the valve covers but can be located on the left side links on this page and purchased separately . Each valve cover has 6 mounting holes so you will need 12, bolts or spreaders etc. when ordering for this set
-
Installation tips :
When tightening your valve cover start on the low side and tighten in a cross pattern to the correct torque spec . Do not over tighten the valve covers when installing them!
-
Comments :
-
If you would like Just the valve covers use MCC111
-
If you would like Just the air cleaner use MCC303-3
-
If you would like a chrome valve cover and air cleaner combo with 440 Magnum emblems use MCC47388
-
All MotorChrome part numbers can be pulled up by typing the MCC# into the search box
