-
Material :
Chrome steel , triple plated Copper /
Nickel / Chrome, With
Phenolic Plastic Emblem.
-
Neck Size : 5 1/8" most four barrels, two barrel
adapters are available in the air cleaner accessories
category
-
Emblems : approximately 1/8" thick and are red and
chrome ,heat and fuel resistant .The are adhered with a
thermal adhesive then baked @ 260 degrees to set the
emblem in place and cannot be removed without damaging
them
-
Stud
and wing nut : A new stud and
standard wing nut will be taped to the inside of your air
cleaner when you receive it. If you would like a fancy
wing nut for your air cleaner checkout MCC1048 ,
MCC1039 or MCC1059
-
Recessed Base
:
This air cleaner comes with a recessed base . It has a
total height of 3" from the carb flange( not including
wing nut). It will fit most Holley carburetors and was
designed for Holley double pumper carbs . If you are
running an Edelbrock carburetor you will need to use
MCC150c 1/2 riser to cleaner the fuel line and/or choke
housing.
-
Application : 351 Windsor ,Cleveland or M engines
-
Installation tips :
Be sure to install the stud
into your carburetor and check your hood clearance to the
stud before closing the hood to avoid damaging your hood
.If necessary cut the stud to the correct height and
reinstall
-
Comments :
-
If you would like the
matching valve covers and this air cleaner for a Windsor
use part number MCC43345 for Cleveland and
M engines use MCC43344
-
If you would like this air cleaner
plain chrome without the emblem use MCC303-3
