|
Part #(MCC43345)
Close up of emblem
|
| Air Cleaner Material |
Chrome steel , triple plated Copper / Nickel / Chrome |
| Size |
The air cleaner is 14 inches in diameter and 3 inches tall |
| Emblem |
Approximately 1/8" thick Nylon . Heat & fuel resistant . Adhered with thermal adhesive then baked @ 260 degrees |
|
Air Cleaner
|
Comes with recessed base, filter, chrome top and a stud and standard wing nut taped inside |
|
Neck Size
|
5 1/8" most four barrels, two barrel adapters are available in the air cleaner accessories category |
|
Stud and wing nut
|
A new stud and standard wing nut will be taped to the inside of your air cleaner when you receive it. in Our
|
|
Base
|
This air cleaner comes with a recessed base. It has a total height of 3" from the carb flange (not including wing nut). It will fit Holley, Demon & Quadrejet carburetors. If you are running an Edelbrock carburetor you will need to use MCC150c 1/2 riser to clear the fuel line and/or choke housing.
|
|
Restrictions
|
Designed for carburetors WILL NOT work on fuel injection
|
|
|
Air Cleaner Installation tips : Be sure to install the stud into your carburetor and check your hood clearance to the stud before closing the hood to avoid damaging your hood. If necessary cut the stud to the correct height and reinstall.
|
|
|
Valve Cover Material
|
Chrome steel , triple plated Copper / Nickel / Chrome |
|
Emblem
|
Approximately 1/8" thick Nylon . Heat & fuel resistant . Adhered with thermal adhesive then baked @ 260 degrees |
| Thickness |
These valve covers are stamped from approximately .040 thick steel. |
| Application |
Generally all Small Block Ford 351 Windsor Carbureted Engines
|
| Pair |
This comes as a set of 2 valve covers
|
| Height |
This set is factory height (approximately 3 1/2 inches tall). Each valve cover has one hole in it for accessories. They CANNOT be run with aftermarket roller rockers
|
| Baffled |
YES, these valve covers come with steel baffles
|
| Gaskets |
NO, these do not come with gaskets. Any Quality gasket made for the small block Ford will work on these valve covers
|
| Valve Cover Accessories
|
Valve Cover Accessories DO NOT come with the valve covers but can be located on the left side links on this page and purchased separately or at the bottom of this page in the related links. Each valve cover has 6 mounting holes so you will need 12, bolts when ordering for this set
|
| Restrictions |
WILL NOT work on engines running E.F.I. fuel injection unless converted to a carburetor
|
|
Valve Cover Installation tips : When tightening your valve covers make sure to tighten them evenly to the correct torque spec. Do not over tighten the valve covers when installing them!
|
