-
Material :
Chrome steel , triple plated Copper / Nickel / Chrome,
With Phenolic Plastic Emblems.
-
Emblems : approximately 1/8" thick and are ,heat and fuel resistant .They are adhered with a thermal adhesive then baked @ 260 degrees to set the emblem in place and cannot be removed without damaging them
-
Thickness : These valve covers are stamped from approximately .040 thick steel.
-
Application : Ford 351 Cleveland, 351 Modified and 351Midland engines
-
Restrictions : Will not clear roller rockers, they are factory height.
-
Valve Covers : This set is factory height (approximately 3 1/4" tall) . Each valve cover has one hole in it for accessories. They CANNOT be run with aftermarket roller rockers
-
Baffled : YES, these valve covers come with steel baffles in each
-
Gaskets : NO, these do not come with gaskets, Any Quality gasket made for your engine will work on these valve covers
-
Valve Cover Accessories : Hold downs, breathers, PCV valves etc. DO NOT come with the valve covers but can be located on the left side links on this page and purchased separately . Each valve cover has 8 mounting holes so you will need 16, bolts or spreaders etc. when ordering for this set
-
Installation tips : When tightening your valve cover start on the low side and tighten in a cross pattern to the correct torque spec . Do not over tighten the valve covers when installing them!
-
Comments :
-
If you would like this as a combo kit meaning valve cover and a 14 inch air cleaner use MCC43344
-
If you would like plain chrome valve covers without emblems use part number MCC113
