-
Material : Chrome steel , triple plated Copper / Nickel / Chrome
-
Bolts : This Bracket DOES NOT come with mounting bolts
-
Set
: This COMES WITH both the upper and lower brackets
-
Thickness: Upper bracket is stamped from approximately .100 thick steel. The lower is made from
approximately .230 thick steel
-
Mounting : The upper bracket mounts to the front of the intake and the mounting ear on the water pump
-
Length of mounting arm to Intake Manifold:
Approximately 4 3/8 (slotted)
-
Waterpump : This bracket is for
small block Chevrolet engines with long water pump and will mount the alternator on the passenger side of the engine just as the factory brackets do.
-
Application : For 1976 thru 1986 305 - 350 - 383 - 400 or any small block Chevy running a long water pump and 1976-1986 style intake manifold or aftermarket with factory mounting holes and accessories hole heads.
-
Restrictions :
Cannot be run with race style intake such as Edelbrock victor Jr (use MCC576581) and cannot be used with "fuelie" or non accessories hole heads
-
Installation : This bracket installs just as your factory bracket mounts. Due to minor variations in factory/aftermarket tolerances on intakes and water pumps mounting holes it is recommended that you install all bolts loosely and then tighten bracket in place evenly.
-
Comments:
-
if you would like the same bracket with a fluted design use MCC0637
-
If you have a long water pump bracket from 1969-1975 that mounts to the water neck use MCC0638 or MCC0578
-
All MotorChrome part numbers can be pulled up by typing the MCC# into the search box
