-
Material :
Chrome steel , triple plated Copper /
Nickel / Chrome, With Phenolic Plastic
Emblem.
-
Air Cleaner
Neck Size : 5 1/8" most four barrels, two barrel
adapters are available in the air cleaner accessories
category
-
Emblems : approximately 1/8" thick and are red and
chrome ,heat and fuel resistant .The are adhered with a
thermal adhesive then baked @ 260 degrees to set the emblem
in place and cannot be removed without damaging them
-
Stud
and wing nut : A new stud and
standard wing nut will be taped to the inside of your air
cleaner when you receive it. If you would like a fancy
wing nut for your air cleaner checkout MCC1048 ,
MCC1039 or MCC1059
-
Recessed Base
:
This air cleaner comes with a recessed base . It has a
total height of 3" from the carb flange( not including
wing nut). It will fit most Holley carburetors and was
designed for Holley double pumper carbs . If you are
running an Edelbrock carburetor you will need to use
MCC150c 1/2 riser to cleaner the fuel line and/or choke
housing.
-
Air Filter : Common 14 x 3 paper element, so when
you need to replace the air filter you can find it locally
or we also carry replacement filters when needed
MCC303-3E, if you would like to add a K&N filter to your
order it is MCC1650
-
Application : Pontiac 350 engines
-
Restrictions
: Will not work with factory air
conditioning
-
Installation tips : Be sure to install the stud
into your carburetor and check your hood clearance to the
stud before closing the hood to avoid damaging your hood
.If necessary cut the stud to the correct height and
reinstall
-
Valve Covers : This set is tall(3 1/2 inches) height
.They will NOT clear factory air
conditioning brackets. Each valve cover has one hole in it
for accessories. They can
be run with aftermarket roller rockers if you have roller
rockers
-
Baffled : YES, these valve covers come with steel
baffles in each
-
Gaskets : NO, these do not come with gaskets, Any
Quality gasket made for the your engine will work on
these valve covers
-
Valve Cover Accessories :
Hold downs, breathers,
PCV valves etc. DO NOT come with the valve covers but can
be located on the left side links on this page and
purchased separately . Each valve cover has 4 mounting
holes so you will need 8 bolts or spreaders etc. when
ordering for this set NOTE:
Pontiac engines use 5 /16 mounting hardware
-
Installation tips : When tightening your valve cover
start on the low side and tighten in a cross pattern to
the correct torque spec . Do not over tighten the valve
covers when installing them!
-
Comments :
-
If you would like just
the valve covers use part number MCC75TB for blue
emblems
-
If you would like just the valve covers use part
number MCC75TR for red emblems
-
If you would like just the air cleaner use part
number MCC71B-3 for blue emblem
-
If you would like just the air cleaner use part
number MCC71R-3 for red emblem
-
If you would like a plain chrome set
with matching
valve cover and air cleaner combo use MCC303110T .
-
All MotorChrome part numbers
can be pulled up by typing the MCC# into the search box
