Close pic up of emblem

Specifications for (MCC77)

Pair : The Price is for 2 valve covers

Emblems : approximately 1/8" thick  and are ,heat and fuel resistant .They are adhered with a thermal adhesive then baked @ 260 degrees to set the emblem in place and cannot be removed without damaging them

Thickness :  These valve covers are stamped from approximately .040 thick steel.

Application :  Big Block Ford 429 and 460 engines

Restrictions : Some 429 and 460s will need 5/16 valve cover gaskets to clear factory rocker arms

Valve Covers : This set is factory height  . Each valve cover has one hole in it for accessories. They CANNOT  be run with aftermarket roller rockers

Baffled : YES, these valve covers come with steel baffles in each

Gaskets : NO, these do not come with gaskets, Any Quality gasket made for the your engine will work on these valve covers

Valve Cover Accessories : Hold downs, breathers, PCV valves etc. DO NOT come with the valve covers but can be located on the left side links on this page and purchased separately . Each valve cover has 7 mounting holes so you will need 14, bolts or spreaders etc. when ordering for this set

Installation tips : When tightening your valve cover start on the low side and tighten in a cross pattern to the correct torque spec . Do not over tighten the valve covers when installing them!

Comments :

If you would like this as a combo kit meaning valve cover and a 14 inch air cleaner use MCC62377

If you would like plain chrome  valve covers without emblems use part number MCC106

All MotorChrome part numbers can be pulled up by typing the MCC# into the search box